Check the fluid level in the
windshield washer reservoir at least
monthly during normal use.
Check the fluid level with the engine
at normal operating temperature.
Fill the reservoir with a good-quality
windshield washer fluid. This
increases the cleaning capability and
prevents freezing in cold weather.
When you refill the reservoir, clean
the edges of the windshield wiper
blades with windshield washer fluid
on a clean cloth. This will help to
condition them.
If the washer fluid is low, a
‘‘WASHER FLUID LOW’’ message
appears on the multi-information
display.
Park the vehicle on level ground.
Start the engine and let it run until
the radiator fan comes on, then
shut off the engine. For accurate
results, wait about 60 seconds
before going to step 2, but don’t
wait longer than 90 seconds.
Remove the dipstick (yellow loop)
from the transmission, and wipe it
with a clean cloth.
1.
2.
Windshield Washers Automatic Transmission Fluid
Windshield Washers, Automatic Transmission Fluid
400
NOTICE:
DIPSTICK
Do not use engine antif reeze
or a vinegar/water solution in the
windshield washer reservoir. Antif reeze
can damage your vehicle’s paint, while
a vinegar/water solution can damage
the windshield washer pump. Use only
commercially-available windshield
washer f luid.
０６／０８／１２ １９：１１：２６ ３１ＳＪＡ６２０ ０４０５
To Next Page
Loading...
