Press SEL/RESET button, then
press the INFO button.
Each time you press the INFO
button, the display changes to ‘‘ON,’’
to ‘‘OFF,’’ then to ‘‘EXIT.’’
Select ‘‘ON’’ or ‘‘OFF’’ by pressing
the INFO button, and enter your
selection by pressing the SEL/
RESET button.
When you push the LOCK button on
the remote transmitter, the door and
trunk locks are set, some of the
exterior lights flash, and a beeper
sounds. If you push the LOCK
button (with the security system set)
again within 5 seconds, the horn
sounds to let you know the security
system is working. You can
customize the Keyless Lock settings
so that the exterior lights do not
flash and/or the acknowledgement
beeper does not sound. While the multi-information display
shows ‘‘DOOR·WINDOW SETUP,’’
press the SEL/RESET button on the
steering wheel. Then press the
INFO button repeatedly until you see
‘‘KEYLESS LOCK
ACKNOWLEDGEMENT’’ as shown
above.
CONTINUED
Multi-Information Display
Keyless Lock Acknowledgement
Instruments and Controls
113
０７／０５／１７ １７：０１：４５ ３１ＳＥＡ６４０ ０１１８
To Next Page
Loading...
Need help?
General
