The headlights revert to normal
operation when you turn them on
with the switch.
The level of brightness is shown on
the multi-information display while
you adjust it. It goes out 5 seconds
after you finish adjusting.
When the multi-information display
shows a ‘‘DRL OFF’’ message, the
daytime running lights are off.
Follow the procedure in the previous
page to turn them on.
To reduce glare at night, the instru-
ment panel illumination dims when
you turn the light switch to or
. Turning the select/reset knob
fully to the right until you hear a
click will cancel the reduced bright-
ness.
If you see a ‘‘CHECK DRL
SYSTEM’’ message on the multi-
information display, there is a
problem in the high beam headlight’s
circuit. Take your vehicle to a dealer
to have it checked.
The select/reset knob on the
instrument panel controls the
brightness of the instrument panel
lights. Turn the knob to adjust the
brightness.
Instrument Panel Brightness
Daytime Running Lights, Instrument Panel Brightness
Instruments and Controls
123
SELECT/RESET KNOB
BRIGHTNESS LEVEL
U.S. model is shown
０７／０５／１７ １７：０３：１７ ３１ＳＥＡ６４０ ０１２８
To Next Page
Loading...
Need help?
General
