You can customize some vehicle
control settings for ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately.
To have the driver’s ID detected,
make sure you use your transmitter
to unlock the driver’s door.
If you use the key to unlock the
driver’s door, the system cannot
recognize either ‘‘DRIVER 1’’ or
‘‘DRIVER 2.’’ In this case, when you
try to enter the customizing mode,
‘‘DRIVER UNKNOWN
CUSTOMIZE IMPOSSIBLE’’ will be
displayed, and you cannot customize
some of the settings.
Refertothetableonpage tosee
what settings you can customize.
If you use your remote transmitter to
unlock the driver’s door, and the
system fails to recognize either
‘‘DRIVER 1’’ or ‘‘DRIVER 2’’ see
page to link your transmitter to
your vehicle.
To use the system, your cell phone
and the HFL system must be linked.
Not all cell phones are compatible
with this system. Refer to page
for instructions on how to link
your cell phone to the HFL and how
to receive or make phone calls, or
visit the acura.com/handsfreelink
website.
With the ignition switch in the ON
(II) position, press and hold the
INFO button for more than 3
seconds. ‘‘CUSTOMIZE ENTRY’’
appears on the multi-information
display.
219
88
132
Multi-Information Display
Customized Settings
86
DRIVER’S
ID
０７／０５／１７ １６：５７：４８ ３１ＳＥＡ６４０ ００９１
To Next Page
Loading...
Need help?
General
