16. Put on the spare tire. Put the
wheel nuts back on finger-tight,
then tighten them in a crisscross
pattern with the wheel nut wrench
until the wheel is firmly against the
hub. Do not try to tighten the
wheel nuts fully.
17. Lower the vehicle to the ground,
and remove the jack.
18. Tighten the wheel nuts securely in
the same crisscross pattern. Have
the wheel nut torque checked at
the nearest automotive service
facility.
Tighten the wheel nuts to:
94 lbf·ft (127 N·m, 13 kgf·m)
19. Remove the center cap from the
flat tire.
20. Place the flat tire face up under the
hoist.
21. Insert the hoist bracket into the
center hole of the flat tire.
CONTINUED
Changing a Flat Tire
429
Taking Care of the Unexpected
08/06/06 16:58:07 09 ACURA MDX MMC North America Owner's M 50 31STX620 enu
To Next Page
Loading...
Need help?
General
