EasyManuals Logo

Acura 2010 RL User Manual

Acura 2010 RL
551 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #184 background imageLoading...
Page #184 background image
In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.
Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current from the
battery.
If the engine is left idling for an
extended period, do not use the
seat heaters, even on the LO
setting. It can weaken the battery,
causing hard starting.
The ignition switch must be in the
ON (II) position to use the heaters.
Push the top of the switch, HI, to
rapidly heat up the seat. After the
seat reaches a comfortable
temperature, select LO by pushing
the bottom of the switch. This will
keep the seat warm.
In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat’s temperature
drops.
Both front seats are equipped with
seat heaters. The passenger seat
only has heaters in the seat bottom
because of the side airbag cutoff
system.
RL models
FrontSeatHeaters
Instruments and Controls
181
Passenger’s
seat
Driver’s
seat
HEATERS
FRONT SEAT HEATER SWITCHES
HI
LOW
09/04/02 19:01:11 31SJA650 0186 
2010 RL

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Acura 2010 RL and is the answer not in the manual?

Acura 2010 RL Specifications

General IconGeneral
BrandAcura
Model2010 RL
CategoryAutomobile
LanguageEnglish

Related product manuals