Depending on the length of time the
battery was disconnected, your
system may require GPS
initialization. If it does, the above
screen appears. Follow the
instructions on the screen.
When you purchased the vehicle,
you should have received two cards
that have the audio and compass
system’s security codes and serial
numbers. Keep these cards in a safe
placeincaseyouneedthecodes.If
you lose the cards, you must obtain
the security codes from your dealer.
Enter the four-digit compass system
security code. If you have entered it
correctly, the display changes to the
. You have ten
chances to enter the correct code. If
all ten are incorrect, turn the ignition
to OFF, then back to ON (II) to have
ten more chances to enter the
correct code.
To enter the code, turn the interface
knob to select the number, then
press the interface selector to enter
it. Keep doing the same procedure to
enter all four correct numbers. If you
need to delete the number you
entered mistakenly, move the
interface selector to the right.
Follow the instructions in the audio
system section to enter the 5-digit
audiocode(seepage ).The
system voice will not operate if the
audio code is not entered
280
CONTINUED
GPS initialization
Compass System (U.S. model without navigation system)
Disclaimer screen
Features
299
０９／０４／０２ １９：１６：３６ ３１ＳＪＡ６５０ ０３０４
To Next Page
Loading...
Need help?
General
