Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the fog lights to test the
new bulb.
Reinstall the two undercover bolts
onthesideundercoverand
tighten them securely. Put the
holding clip back on the side
undercover and push on the center
until it locks (the center is flush
with the head).
Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
Remove the bulb by turning it one-
quarter turn counterclockwise.
Carefully push up the side under
cover into the bumper.
Use a Phillips-head screwdriver to
remove the two undercover bolts,
and remove the holding clip with a
flat-tip screwdriver.
3.
4.
5.
6.
8.
7.
1.
2.
Lights
Maintenance
467
CLIP
CONNECTOR
BULB
BOLTS
０９／０４／０２ １９：３８：４９ ３１ＳＪＡ６５０ ０４７２
To Next Page
Loading...
Need help?
General
