Pull to the side of the road when it is
safe, shift to Park, and let the engine
idle until the indicator goes out.
You will also see a ‘‘CHECK TIRE
PRESSURE’’ message on the multi-
information display (see page ).
Check the tire pressure monitor on
the multi-information display and
determinethecause(seepage ).
If this happens, pull to the side of the
road when it is safe, check which tire
has lost pressure on the multi-
information display, and determine
the cause. If it is because of a flat tire,
have the flat tire repaired as soon as
possible. If two or more tires are
underinflated, call a professional
towing service. For more
information, see page .
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
This indicator has two functions:
If it comes on while driving, it
indicates that one or more of your
vehicle’s tires are significantly low
on pressure.
If this indicator begins to flash,
there is a problem with the tire
pressure monitoring system
(TPMS). You will also see a
‘‘CHECK TPMS SYSTEM’’
message on the multi-information
display. The indicator continues to
flash for a while (approximately 1
minute), then stays on. If this
happens, have your dealer check
the system as soon as possible.
For more information, see page
.
1.
2.
79
425
513
423
Instrument Panel Indicators
Low Tire Pressure/
TPMS Indicator
Instruments and Controls
67
Continuing to drive with the SH-AWD
indicator blinking may cause serious
damage to the system.
０９／０４／０２ １８：４６：３９ ３１ＳＪＡ６５０ ００７２
To Next Page
Loading...
Need help?
General
