A U T O M A T I C B R A K E H O L D
Maintains rear brake hold even after the brake pedal is released.
E L E C T R I C P A R K I N G B R A K E
Keep your vehicle stationary while parked using a simple switch.
A p p l y i n g t h e P a r k i n g B r a k e
R e l e a s i n g t h e P a r k i n g B r a k e
24
10
H o w I t W o r k s
1. Make sure the vehicle is on and
your seat belt is fastened.
2. Press BRAKE HOLD. The BRAKE
HOLD indicator turns on.
Note: Brake hold is canceled if the system is on for more than 10 minutes,
your seat belt is unfastened, or you turn the vehicle off.
25
Pull up the
parking brake
switch.
The PARK
indicator turns
on.
Press the
parking brake
switch with
your foot on
the brake
pedal and
your seat belt
fastened.
You can also
lightly depress the
accelerator
pedal if your seat
belt is fastened
and the vehicle is
on and not in
Park.
3. With the shift lever in Drive
(D), depress the brake pedal
and come to a complete
stop. The HOLD indicator
appears and brake hold is
applied. Release the brake
pedal.
4. Depress the brake pedal
and press BRAKE HOLD
again to turn off the system.
Depress the accelerator
pedal to cancel brake hold
and start moving.
To Next Page
Loading...
