23
O p e r a t i n g A C C
ADAPTIVE CRUISE CONTROL (ACC) WITH LOW SPEED FOLLOW
Set a time or space interval between your vehicle and the vehicle ahead of you.
When the vehicle ahead changes speed, ACC senses the change and accelerates or
decelerates your vehicle's speed to maintain a set range. Available with Advance
Package.
Check the MID for
ACC information.
22
Press the Distance button to shuffle
through four ranges.
The selected range and set speed are shown in the MID.
Note: The ACC radar sensor in the front grille can detect and monitor the distance of a
vehicle up to approximately 100 yards ahead.
C h a n g i n g V e h i c l e D i s t a n c e
Control the distance between your vehicle and the vehicle in front of you.
H o w t o U s e A C C
U s i n g A C C
1. Accelerate to the desired speed.
Above 25 mph: Go to step 2.
Below 25 mph (Low Speed Follow): Press SET/- to set the speed at 25 mph
when there is a vehicle ahead of you. If there is no vehicle ahead, ACC is
canceled.
2. Press SET/-, then release the accelerator pedal. The set speed is fixed, and
ACC begins.
3. To increase speed, press RES/+. To decrease speed, press SET/-.
4. If the vehicle ahead of you stops, your vehicle also stops. When the vehicle
ahead starts to accelerate, press RES/+ or SET/- or depress the accelerator
pedal to resume following at the set speed.
S t a n d a r d C r u i s e C o n t r o l
1. Press and hold the Distance button.
2. A beep sounds, and the selected mode appears in the MID.
MAIN
SET/-
Distance
RES/+
CANCEL
Range MID Screen
Extra Long
Long
Middle
Short
If there is no vehicle ahead of
you, a dotted-line vehicle icon
appears on the MID.
If a vehicle enters the ACC
range, a beep sounds and a
vehicle icon appears on the MID.
Short
range
Normal
range
Long
range
Extra Long
Range
ACC automatically adjusts the following distance based on the
range selected and your vehicle speed.
Turning ACC On
Press MAIN. ACC appears in the MID.
Canceling ACC
Press MAIN or CANCEL, or tap the brake
pedal.
To Next Page
Loading...
