CLIENT INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment,
and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not
assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies,
contact an authorized Acura automobile dealer.
© 2017 American Honda Motor Co., Inc. – All Rights Reserved Page 1 of 11
May 23, 2017 06358 Version 1
2018 TLX: TQI and New Model Service Information
AFFECTED VEHICLES
8-Speed DCT
9-Speed A/T
9-Speed A/T, Auto Idle Stop
INTRODUCTION
This bulletin covers the total quality inspection (TQI) of the 2018 TLX. It includes these procedures:
1. Install the Backup Fuse 11. Do the PCM Idle Learn Procedure
2. Fuel the Vehicle 12. Do the CKP-Pattern Learn Procedure
3. Remove the Exterior Protective Coatings 13. Install the Shift Lock Release Cover
4. Remove the Interior Protective Coverings 14. Initialize the Audio Unit (Trim Levels Without
Navigation)
5. Install the Floor Mats 15. Set the Clock (Trim Levels Without Navigation)
6. Check the Battery 16. Set the Compass Zone (Trim Levels Without
Navigation)
7. Install the Body Plugs 17. Check the Compass Calibration (Trim Levels
Without Navigation)
8. Install the Front Strakes 18. Check/Refresh the SiriusXM
®
Radio Dealer Demo
Service (Except in Alaska and Hawaii)
9. Install the Front License Plate Holder 19. Check the ACC, LKAS, Lane Departure Warning,
Forward Collision Warning, Collision Mitigation
Braking System
™,
and Road Departure Mitigation
Indicators
10. Set the Tire Pressures, and Remove the
TPMS Labels
20. Check Bluetooth
®
HandsFreeLink
®
(HFL)
To do a TQI on a model with a navigation system, be sure to complete S/B 17-023, 2018 TLX: TQI of the Navigation
System.
To Next Page
Need help?
General
