If desired, you can use the
adjustment switches to change the
seat position after it is in its
memorized position. If you change
the memorized position, the
indicator in the memory button will
go out. To keep this seat position for
later use, you must store it in the
driver’s seat position memory.
Pressing any of the seat
adjustment switches.
Shifting out of Park (A/T), or into
reverse (M/T).
Any of these actions will stop the
system’s automatic seat adjustment:
The system will move the driver’s
seat to the memorized position. The
indicator in the selected memory
button will flash during movement.
When the adjustment is complete,
you will hear two beeps, and the
indicator will stay on.
Pressing either memory button or
the MEMO button on the driver’s
door.
You cannot select a memorized
position if the transmission is in
reverse. Shift to another gear,
then select a position.
If the parking brake is not set, you
must press and hold the memory
button until the adjustment is
complete.
Notes for vehicles with M/T
Driving Position Memory System
144
０６／０９／０８ ２０：３２：５９ ３１ＳＥＡ６３０ ０１４９
To Next Page
Loading...
Need help?
General
