When buying a child seat, you need
to choose either a conventional child
seat, or one designed for use with
the lower anchors and tethers for
children (LATCH) system.
Conventional child seats must be
secured to a vehicle with a seat belt,
whereas LATCH-compatible seats
are secured by attaching the seat to
hardware built into the two outer
seating positions in the back seat.
Whatever type of seat you choose, to
provide proper protection, a child
seat should meet three
requirements:
Look for FMVSS
213 or CMVSS 213 on the box.
Before purchasing a conventional
child seat, or using a previously
purchased one, we recommend that
you test the seat in the specific
vehicle seating position or positions
where the seat will be used.
Rear-facing for infants, forward-
facing for small children.
Since LATCH-compatible child seats
are easier to install and reduce the
possibility of improper installation,
we recommend selecting this style.
In seating positions and vehicles not
equipped with LATCH, a LATCH-
compatible child seat can be installed
using a seat belt.
1.
2.
3.
The child seat should meet U.S. or
Canadian Motor Vehicle Safety
Standard 213.
The child seat should fit the
vehicle seating position (or
positions) where it will be used.
The child seat should be of the
proper type and size to fit the child.
Selecting Child Seats
44
０６／０９／０８ ２０：１９：５８ ３１ＳＥＡ６３０ ００４９
To Next Page
Loading...
Need help?
General
