−
−
You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN, the
preset buttons or icons, and AUTO
SELECT.
Pushing the AUDIO DISPLAY
button will also turn on the system.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the FM/AM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
XM satellite radio information is
available on page .
The audio system for your vehicle
can also be operated using the voice
control system. See the Navi section
in your Quick Start Guide for an
overview of this system, and the
Navigation System manual for
complete details.
Use the TUNE/SOUND
knob to tune the radio to a desired
frequency. Turn the knob right to
tune to a higher frequency, and turn
theknoblefttotunetoalower
frequency.
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Turn the system on by
pushingtheVOL/PWRknoborthe
AM/FM button. Adjust the volume
by turning the same knob.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the or side of the
SEEK/SKIP bar, then release it.
179
On vehicles with navigation system
On vehicles with navigation system
On U.S. models
Playing the AM/FM Radio
To Select a StationTo Play the AM/FM RadioVoice Control System
TUNE
SEEK
172
０６／０９／０８ ２０：３６：２５ ３１ＳＥＡ６３０ ０１７７
To Next Page
Loading...
Need help?
General
