Lift it up slightly to remove the
support rod from the hole. Put the
support rod back into its holding clip.
Lower the hood to about a foot
(30cm)abovethefender,thenletit
drop. Make sure it is securely
latched.
To Close the Hood:
Put your fingers under the front
edge of the hood near the center.
Slide your hand to the left until
you feel the hood latch handle.
Push this handle up to release it.
Lift up the hood.
If the hood latch handle moves stiffly,
or if you can open the hood without
lifting the handle, the mechanism
should be cleaned and lubricated.
Pull the support rod out of its clip
by holding the grip, and insert the
end into the designated hole in the
hood.
3.2.
Service Station Procedure
Before Driving
233
LATCH
SUPPORT ROD
GRIP
CLIP
０６／０９／０８ ２０：４４：３６ ３１ＳＥＡ６３０ ０２３８
To Next Page
Loading...
Need help?
General
