Check the fluid level with the
transmission at normal operating
temperature and the vehicle sitting
on level ground. Remove the
transmission filler bolt, and carefully
feel inside the bolt hole with your
finger. The fluid level should be up
to the edge of the bolt hole. If it is
not, add Honda Manual
Transmission Fluid (MTF) until it
starts to run out of the hole. Reinstall
the filler bolt, and tighten it securely.
To check the transmission fluid level,
remove the two bolts, then pull the
left part of the under cover down.
After checking and adding the fluid,
put the under cover back in place
and tighten the bolts securely.
If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certification seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives, and continued use can
cause stiffer shifting. Replace as
soon as it is convenient.
Ifyouarenotsurehowtoaddfluid,
contact your dealer.
Manual Transmission
Transmission Fluid
Maintenance
295
FILLER BOLT
Correct level
BOLT
UNDER COVERBOLT
０６／０９／０８ ２０：５２：１４ ３１ＳＥＡ６３０ ０３００
To Next Page
Loading...
Need help?
General
