BEDIENUNGSANLEITUNG
USER'S
MANUALI
MANUEL
D'UTILISATION
SLT001
/
SLT001W
MULTI-PURPOSE
LAPTOP
STAND
PARTS
Lower
Support (
Fiat
Stabilizer
Foot
Bar
Bar
(2)
(2)
Knobs
(4)
C-Clamps
Washers A Washers B
(2) (8) (4)
!
Spacers
Screws
A
Screws
B
(2) (8) (4)
ÉÉ^"
Place
Upper
^
support over
S&
Lower support, so
WÊ\,
the Upper
•S^M\t is on the
^fcA outside of the
Knobs
must be
spaced
at least 2
Figure
A
hoies
apart
1.
Take
one of the upper supports and place it over the outside of one of the lower supports
(see
figure
A).
Align the upper support hoies
with
the
lower support
mounting
hoies to
obtain
the desired height.
2.
Place
one knob at a
time
through
the
mounting
hoies (must be
spaced
at least 2 hoies apart).
3.
Take
a stabilizer bar
and
screw the top knob
into
the end of the stabilizer bar.
Repeat
with
bottom
knob.
4.
Install
1
inch
spacers
on
each
stabilizer bar to
increase
stand width.
Repeat
step 3
with
the other upper support
and
lower support for the opposite
side
of the stand
(see
Figure
B).
Secure
ail knobs
tight
to minimize stand wobble.
Table top
assembly
1.
Attach flat
foot
bar to lower support
with
two
(2)
A-screws
and
washers
(see
figure
C).
2.
Repeat
above
with
the other lower
support for the opposite side of the
stand.
B-Screw
-
B-Washer
Figure
D
Table
C-clamp
assembly
1.
Tu
m clamp
with
knobs facing down
and attach to lower support
with
two
(2)
B-screws
and
B-washers
(see
figure D).
2.
Repeat
above
with
the other lower
support for the opposite side of the
stand.
DJ
coffin
C-clamp
assembly
1.
Turn clamp
with
knobs facing back
of stand and attach to lower support
with
two (2)
B-screws
and
B-washers
(see
figure
E).
2.
Repeat
above
with
the other lower
support for the opposite side of the
stand.
Adam Hall GmbH • Dalmlerstr. 9
•
61267 Neu-Anspach- Germany
Tel.:
(+49) 60
81
/ 94 19 0
• Fax.:
(+49) 60
81
/94 19 1000
•
e-mail: mail@adamhall.com
To Next Page
Need help?
General
Weight and Dimensions