07
SECTION 03
INSTALLATION
Please ensure the wall and floor are flat before installing this stove into a surround or
hearth.
USE
The appliance is controlled using 4 switches, located on the side of the stove. Use the
following sequence to operate. The grey represents a ‘pressed switch.’ A switch is in
the ON position when the side with the markings on (e.g. I or II) is 'pressed in’.
On/Off
with Effect
only
Cool Air
Blow &
Effect
1kW Heat
setting
2kW Heat
setting
CARE
• The stove can be cleaned using a damp cloth.
• If the supply cord is damaged, it must be replaced by a suitably qualified person.
• The area around the stove should be kept free from animal hair, lint and other
extraneous material that may be drawn into the workings of the appliance
which could affect its performance.
To Next Page
Loading...