13
MANUAL BACKUP
(LIFT UP FEATURE)
I. Using the ¼ inch hex tool (ratchet) in the inner hole; turn CLOCKWISE. Turn and TILT until the unit is almost touching the
ground.
(Note: Even though the visual indicator on the front of the unit says to turn counter clockwise, you must turn clockwise at this
step)
II. Then TRAVEL the seat back using the ¼ inch hex tool (ratchet) in the outer hole and turn CLOCKWISE until the seat is
level. Then simply follow the aforementioned steps.
*NOTE: Be careful not to disconnect or constrict the wires when manually moving the LINK.
Once the problem is resolved, do not forget to return your back up tools to where you found them.
Please contact your dealer for full diagnostics and needed repairs.
To Next Page
Loading...