ADCA
VALSTEAM
ADCA
We reserve the right to change the design and material of this product without notice.
IMI RP45.02 E 07.16
Remarks:
* By-pass is optional. In case the by-pass is not allowed than stop valve 9B should be placed after pressure gauge
14 allowing the isolation of safety valve.
PN, classes and materials according to the operating pressures.
The balance pipe connection is recommended to enter downstream pipe at a minimum of 1 meter from the valve.
Information sheet are available (IS - RP45) and typical assembling drawing.
Special assembling designs may be produced on request.
PRODUCTS RETURNING
- Information regarding any hazards and precautions to be considered because of contaminating fluids and
residues or mechanical damage that may represent a health, safety or environmental risk, must be provided in
writing by the distributors and costumers when returning products to Valsteam ADCA engineering.
- Health and safety data sheets regarding substances identified as hazardous or potentially hazardous must be
provided with the information mention above.
- LOSS OF WARRANTY: Total or partial disregard of above instructions involves loss of any right to warranty.
To Previous Page
Loading...