Add-com A10L - Connect Telephone and Headset; Adjust the Amplifier Settings

2 Connect Telephone and Headset
• Unplug your telephone handset from the telephone; connect it to the A10L’s HANDSET
socket.
• Connect the Phone Connection cord between the A10L’s TELEPHONE socket and the
Handset socket of the telephone.
• Connect your headset’s plug to the A10L’s HEADSET socket.
3 Adjust the Amplifier Settings
INITIAL SETTINGS
The switches and controls under the A10L allow it to be adapted to a wide range of telephone
types. These controls must be set up to optimise the A10L for your particular phone.
The settings below are a good starting point when setting up your A10L:
• Receiving Volume Control is set to medium level.
• Transmit Volume switch is set to medium level.
• Headset/Handset button in “Handset” position.
• “N-R” switch in “N” position
• “A-B” switch in “A” position
• “C-D” switch in “C” position
CHECK YOUR HANDSET
• Lift the handset from the telephone. You should hear dial tone at the handset.
• If you hear no dial tone, check the connections you made in Section 2, and then check
the position of the Headset/Handset switch.
• Make a phone call to a colleague; ask the colleague to stay on line until you have set
up the A10L.
Setup