Start-up
Charging the battery
− Connect the supplied USB cable to the USB
connector of the blood pressure monitor and
to the USB port of a computer (PC, Tablet,
Notebook) or a USB charging device.
Observe the contacts of the USB connector and
the charging icon in the display.
As soon as the battery icon in the display no
longer flashes, the battery is fully charged and the
blood pressure monitor is ready for use.
A full battery charge lasts - depending
on the use - approx. 20 days.
As soon as a battery icon and "Lo"
appear in the display, you need to
recharge the battery.
Set time and date
1. Press and hold the /SET button until the hour
indicator flashes in the display.
2. Set the current hour-time using the /MEM
button. The time is set using the 12-hour system:
Morning hours are displayed with "AM" and
afternoon hours with "PM".
3. Press the /SET button to store the set
hour-time.
4. Proceed as described in order to set the following
values in succession: Hours > Minutes> Month >
Day > Year.
5. Finally, press /SET.
As soon as “done” appears on the display, the
process is complete.
The device switches off after approx. 60 seconds.
Please leave it switched off.
Druckbuch BPM 1600_EN.indb 6 29.07.2016 14:26:32
To Next Page
Loading...