8
7. Technical Data
Note:
- that the declared vibration total value has been measured in accordance with a standard test method and
may be used for comparing one tool with another;
- that the declared vibration total value may also be used in a preliminary assessment of exposure.
- warning: the vibration emission during actual use of the power tool can differ from the declared total value
depending on the ways in which the tool is used”.
- warning: avoid vibration risk
suggestion: 1) wear glove during operation;
2) limit operating time and shorten trigger time.
Wear hearing protection while operating the power tool.
The declared vibration total value has been measured in accordance with a standard test method and may
be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning
The vibration emission during actual use of the power tool can differ from the declared total value depending
on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle in addition to the trigger time).
Level of acoustic pressure LpA (KpA=3dB(A)), here LpA is 56 dB(A)
Level of acoustic power LwA (KwA=3dB(A)), here LwA is 67 dB(A)
Level of vibration ah (K=1.5m/s ), here ah is < 2.5 m/s
22
EN
T
ype designation ML-CS24-36-A
Rated Voltage 3.6V d.c.
No-load Speed 180min
Chuck capacity 6.37mm
Max.torque 2.5N·m
Max screw size ø3mm x L 12mm
Battery AA600 1.2 Vd.c. Ni-MH 600mAh
Cell quantity in the tool 3
Charger
charge time
3-5h
-1
Model:JLH050700250G2
Input:100-240VAC 50-60Hz
10W
Output:7.0VDC 0.25A 1.75W
To Next Page
Loading...