ADEO Services ZSPQ250-D User Manual

ADEO Services ZSPQ250-D

86 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

EN

Original instructions

Instruction manual

Submersible Pump

ZSPQ250-D(VC250ECL)

ADEO Services

135 Rue Sadi Carnot - CS 00001

59790 RONCHIN – France

Made in P.R.C. 2019

Table of Contents

Questions and Answers:

F
flemingjenniferAug 6, 2025
What to do if ADEO Services ZSPQ250-D doesn’t start or suddenly stops during operation?
- J
  Joseph FieldsAug 6, 2025
  If your ADEO Services Water Pump doesn’t start or suddenly stops, here are a few things to check: * The thermal overload switch may have turned off the pump because it's too hot. Disconnect the plug, clean the turbine, and make sure the media temperature is not more than 35 degrees. * Check the fuses and electrical connections to ensure the pump is getting power. * The suction base might be blocked with dirt. Disconnect the plug and clean the suction base.
K
Keith BurgessAug 16, 2025
Why ADEO Services Water Pump is running but doesn’t deliver water?
- J
  Jeremy LopezAug 16, 2025
  If your ADEO Services Water Pump is running but not delivering water, it could be due to several reasons: * The pressure line might be closed, preventing air from escaping. Open the pressure line, for example, if the pressure pipe is kinked. * There might be air locks in the suction base. Wait up to 60 seconds for the pump to automatically vent the air through the vent valve. If needed, switch the pump off and then on again. * The turbine could be clogged. Disconnect the plug and clean the turbine. * When starting the pump, the water height might be below the minimum level. Submerge the pump deeper.

ADEO Services ZSPQ250-D Specifications

General

Brand	ADEO Services
Model	ZSPQ250-D
Category	Water Pump
Language	English