OPERATION
First use
Before using your blender for the first time you should ensure
that the components are thoroughly cleaned.
Follow the instructions in the Care and Cleaning section to •
clean all components thoroughly before first use.
Fitting the blender stem
The blender stem should be fitted to the motor body before use.
Fit the motor body onto the stem with the •
unlock marking
on the motor body aligned with the pointer on the stem as
shown.
Twist the motor body clockwise until the •
lock marking is
aligned with the pointer.
The stem will be locked in place.
Removing the blender stem
Twist the motor body anti-clockwise until the •
unlock
marking is aligned with the pointer.
Lift the stem off the motor body.•
To Next Page
Loading...