ADF LINEA 85 - Page 5

ADF LINEA 820 NMV ZERO CLEARANCE BOX ASSEMBLY INSTRUCTIONS 1/8/23
5
Dimensions for Heat Resistant board:
• Heat Resistant Non Combustible Board – Fibre Cement Sheet of 18mm thick
to prevent cracking, (as used in Test) or Skamol Board 40mm, required to
300mm above and 100mm each side of the heater.
• Check with sheet manufacturer to confirm specifications suitability.
• Fix with separate sheets top and bottom, and separate off cuts on each side.
Use the factory cut neat edge to face the heater opening, if not covering
with optional frame or tiling.
Must leave a 5mm gap between each edge of the heater and the heat resistant
non-combustible board to allow for metal expansion.
1420mm
1095mm opening.
1140mm to 45mm stud centres.
300mm
above ZCB