ADIR ADIKI300-01 Series

Need help?

Do you have a question about the ADIR ADIKI300-01 Series and is the answer not in the manual?

Summary

Paper Roll Dispenser User Guide

Product Overview and Safety

General introduction to the AdirKids paper roll dispenser and safety commitment.

Parts Identification

Bottom Frame

Component A: The base structure of the paper roll dispenser.

Bottom Spring Arm

Component B (x5): Supports for the paper rolls at the base.

Top Frame

Component C: The upper structure supporting the dispenser.

Top Spring Arm

Component D (x5): Supports for the paper rolls at the top.

Caster Wheel

Component E (x5): Wheels for mobility of the dispenser.

Roll Rest

Component F (x5): Supports for holding the paper rolls.

Vertical Pole

Component G (x5): Vertical supports for the dispenser structure.

Cutter Blade

Component H (x5): Blades for cutting paper rolls.

Paper Roll Rod

Component I (x5): Rods to hold paper rolls in place.

Bottom Bracket

Component J (x5): Brackets for securing the base.

Hardware Identification

Screws and Nuts

Various screws (M6*10, M6*35, M8*80) and nuts (M6, M8 capped) for assembly.

Wrenches and Washers

Tools (8mm, 6mm Wrenches) and fasteners (Washers) included for assembly.

Assembly Instructions

Step 1: Attaching Bottom Spring Arms

Attaching five bottom spring arms to the bottom frame using screws and wrench.

Step 2: Attaching Top Spring Arms

Attaching five top spring arms to the top frame using screws and wrench.

Step 3: Affixing Caster Wheels

Securing five caster wheels to the bottom frame using nuts and wrench.

Step 4: Attaching Roll Rests

Attaching five roll rests to the inner ring of the bottom frame.

Step 5: Installing Vertical Poles

Installing five vertical poles into the predrilled holes on the inner ring.

Step 6: Attaching Bottom Brackets

Sliding and securing bottom brackets onto the vertical poles.

Step 7: Securing Top Frame

Placing and affixing the top frame onto the vertical poles.

Step 8: Attaching Cutter Blades

Attaching five cutter blades to the spring arms using nuts and wrench.

Step 9: Inserting Paper Roll Rods

Inserting five paper roll rods into the top frame to complete assembly.

Loading Paper

Step 1: Positioning Paper Roll

Placing a paper roll onto a roll rest and aligning it with the spindle.

Step 2: Securing Paper Roll Rods

Inserting paper roll rods through the top frame and paper roll.

Cutting Paper

Step 1: Positioning Cutter Blade

Ensuring the cutter blade is correctly positioned for a clean cut.

Warranty Information