How to troubleshoot Adirondack Spas Hot Tub not operating?
If your Adirondack Spas Hot Tub is not operating, the possible causes include a power failure (check the power source), a tripped GFCI breaker (try resetting it; if it continues to trip, contact your dealer). It could also be due to a Main Fuse Class G or Transformer Fuse issue, in which case you should contact your dealer.
Why doesn't the water clear up in my Adirondack Spas MARCY?
If the water in your Adirondack Spas Hot Tub isn't clearing up, it could be due to several reasons. Bad water chemistry can be a culprit, so ensure you balance the water. Dirty filter cartridges can also cause this issue, so clean or replace them. Check if the ozone generator is operating by looking for a purple ultraviolet light. Lastly, low bromine/chlorine residual levels may be the cause; adjust these levels, shock the water if necessary, and consider replacing the water if needed.
How to fix Adirondack Spas MARCY Hot Tub not heating?
If your Adirondack Spas Hot Tub is not heating, it could be due to dirty filters (clean them), a temperature setting that is too low (increase it), or air trapped in the circulation line (force water through the filter cartridge opening with a garden hose or loosen the bottom heater union to release trapped air). If none of these work, Sensor A or B might not be working, and you should contact your dealer.
General| Brand | Adirondack Spas |
|---|---|
| Model | MARCY |
| Category | Hot Tub |
| Language | English |
To Next Page