Admiral AAW-05CR1FHU User Manual (English)

Questions and Answers:

S
sarah44Aug 3, 2025
Why is my Admiral AAW-05CR1FHU Air Conditioner not cooling properly?
- M
  Michelle WoodwardAug 3, 2025
  Several factors can cause inefficient or no cooling in your Admiral Air Conditioner. It could be due to a dirty air filter, which requires cleaning or replacement. The unit might be the wrong capacity for the room, in which case you should consult with a dealer. There might be blocked airflow from obstructions on the grill or outdoor louvers. Also, a power interruption, rapid settings changes, or a tripped compressor overload could be the cause. If it's a compressor issue, let the fan run to allow the compressor to restart (this usually takes about 10 minutes).
T
Tara TorresAug 8, 2025
How to fix an Admiral AAW-05CR1FHU that won't turn on?
- V
  vhudsonAug 8, 2025
  If your Admiral Air Conditioner isn't turning on, there are a few things to check: * First, ensure the power cord is securely connected to the power source. * Next, inspect the fuse or circuit breaker to see if it has tripped. * Finally, make sure the MODE knob is set to a position other than "OFF".
M
Maria HancockAug 12, 2025
What to do if my Admiral Air Conditioner has ice or frost build-up?
- S
  Sara SmithAug 12, 2025
  If you notice ice or frost build-up on your Admiral Air Conditioner, it could be due to a low outside temperature (around 65°F or below) while the unit is in cooling mode. To resolve this, switch the unit to FAN (only) operation until the frost melts. Also, a dirty air filter can cause this issue, so remove and clean the filter.
L
Lindsey GriffinAug 16, 2025
Why is my Admiral AAW-05CR1FHU dripping water inside?
- R
  Raymond SharpAug 16, 2025
  If your Admiral Air Conditioner is dripping water inside, it's likely because the unit isn't properly angled to allow water to drain outside. The unit needs to be installed on an angle for proper condensation run-off. Inspect the unit and make necessary adjustments to correct the angle.