09
Adjustment methods of each part
VIII.Instructions for using the code table:
1.Press the POWNER button three seconds to start. And press the button for three
seconds to close.
2.After starting up, press the POWER button to switch to display the total mileage, single
mileage and battery voltage.
3.Press the "+" or "." button for a long time to enter the mode setting; Control the gear,
Increase/decrease one gear every time, and follow the 1-3 gear.
Note: First gear to pedal power, no power to handle.
Second gear medium power assist, Third gear high speed power assist.
Note: Before using the bicycle, insert the key and turn it counterclockwise by 45°,
the battery is activated. Finished using the bicycle, turn the key 45° clock wise, the
battery is powered off, and take out the key. Remove the battery step, insert the
key, press it upward and then rotate it 90° clockwise. Note that need to remove the
key and then take out the battery to avoid damaging the key.
3.Take out the battery and charge the
battery separately
4. You can also choosevehicle
charging
Red light indicates normal charging Green
light indicates charging completed
Switch on/off
Battery power Speed display
Assist gear
Vehicle status
Multifunctional display area
To Next Page
Loading...
