ADO A20F - Final Adjustments and Tire Inflation; Operation Guide; Starting and Stopping the Ebike; Navigating Display Information

45°
90°
1
2
30°
45°
16. Finish the installation, use the pump to inflate the
tires.
15. Turn the headlight to the front 30 degrees down
position，use the tool to twist the screws.
17. Before using the bicycle, insert the key and twist
45°counterclockwise, the battery has been started.
19.The step of removing battery, insert the key, press upward and then rotate 90°clockwise.
Note:Remove the key firstly,and then take out key and then take out the battery to avoid damaging the key.
18. Finished using the bicycle, turn the key 45°clockwise,
the battery has been disconnected, and take out the key.
8
1.In shutdown state, long press Power key for 3 second to start the ebike;
2.In the power on state, Long press Power key for 3 second to off the ebike;
3.In the power-on state, press POWER KEY, the multi-function area will display ODO, VOL, TRIP, TIME.
ODO: The total mileage of this bicycle when it is turned on
VOL: Current battery voltage value display
TRIP: Mileage traveled after this start
TIME: The time since the start of this ride
4. Press the “+” button to increase the gear. The higher the gear, the faster the speed.
5. Press the “-” button to lower the gear. The lower the gear, the slower the speed.
Switch on/off
Battery power display
Speed display
Assist gear display
Assist gear
adjustment
Multifunctional display area
SPEED
km/h
km
Operation Guide
3