To Next Page

To Previous Page

Step 3: Attach the cable to the micro-USB connector

Note: If you plan to install the Wi-Fi option, first complete the ADP QuickPunch Plus installation. The cable (as

shown in the following illustration) must be in place before you fasten the Wi-Fi assembly to the CPU board.

That is, the cable lies beneath the Wi-Fi assembly.

Route the cable underneath the badge reader wires (if installed), and attach it to the micro-USB connector.

micro-USB connector

Questions and Answers:

Need help?

Do you have a question about the Adp QuickPunch Plus and is the answer not in the manual?

Adp QuickPunch Plus Specifications

General