Need help?Do you have a question about the Adrian Olson ODOM and is the answer not in the manual?
General| Brand | Adrian Olson |
|---|---|
| Model | ODOM |
| Category | Toy |
| Language | English |
Procedure for drilling holes for the keel bolts in the hull.
Procedure for drilling the hole for the rudder shaft in the hull.
Mounting the sail servo and connecting its control horn.
Mounting the rudder servo and routing its wire.
Checking alignment of the keel bulb with the keel fin.
Securing the keel bulb to the keel fin using adhesive.
Applying fillets and finishing the keel bulb surface.
Preparing the mast, including crane and shroud exit holes.
Attaching the mast step pin and gooseneck/vang assembly to the mast.
Installing the forestay wire and its associated lines.
Connecting jib club, topping lift, and outhaul to the jib sail.
Attaching the main sail, including downhaul and outhaul lines.
Final installation of the keel and rudder assembly.
Connecting the main and jib sheets for sail control.
Raising and tensioning the mast and rigging.
To Next Page