Nero SoundTrax – CD track split detection and editing
When using the wizard, Nero uses automatic track detection to break your recording up into separate CD
tracks. This is done based upon the silences between songs.
1) When on the track detection phase of the wizard, click on the “Detect” button. Nero should show a
picture of your file with lines indicating where the songs are split.
2) You can increase the sensitivity of
the automatic track detection by
increasing the “Silence Threshold”
or by lowering the “Minimum
duration of pause.” You can
decrease the sensitivity by doing
the opposite.
3) Click “Detect” after making a
change to see its effects on your
file.
4) If you do not see any track split
lines when you click “Detect”
then when you burn a CD, all of
your music will be on one long
track.
Editing track splits manually:
If the program does not put track splits where you want them, even after making adjustments, then you will
want to do this manually. When
recording dialog or albums with songs
that run together without pauses in
between, the automatic track detection
will not work for you and you will need
to do it this way.
1) Finish the wizard without opting
to burn the project.
To Next Page
