ADS ADS1000 User Manual

How to connect the ADS1000 external gas sampling system
To connect the external gas sampling system perform the following steps:
1) Insert the Luer lock connector to the gas sampling input and rotate it clockwise one
half turn.
2) Connect the two breathing circuits ends to the breathing circuit ports.
3) Now insert the gas sampling elbow into the end of the breathing circuit as shown.
4) Insert the Luer lock connector to the gas sampling elbow and rotate it clockwise one
half turn.
5) Connect breathing circuit to the gas sampling elbow.
1099 East 47 Street, Hialeah, Florida 33013
305-688-8581 - 800-445-8581 - FAX 305-685-7671
3) Connect
Gas
sampling
elbow
4) Connect
Luer lock
connecto
r
5) Connect
breathing
circui
t
2) Connect
breathing
circuit
1) Connect
Luer lock
connecto
r

ADS ADS1000 Specifications

General

Brand	ADS
Model	ADS1000
Category	Medical Equipment
Language	English

Summary

Connecting the ADS1000 External Gas Sampling System

Connect Luer Lock to Gas Sampling Input

Insert and rotate Luer lock connector clockwise to gas sampling input.

Connect Breathing Circuits

Connect both ends of the breathing circuits to the designated ports.

Connect Gas Sampling Elbow to Breathing Circuit

Insert the gas sampling elbow into the end of the breathing circuit.

Connect Luer Lock to Gas Sampling Elbow

Insert and rotate Luer lock connector clockwise to the gas sampling elbow.

ADS1000 Safety and Operational Warnings

Critical Importance of Gas Sampling System

Highlights the vital necessity of the Gas Sampling System during procedures and risks of non-use.

Consequences of Disconnection

Explains severe patient harm or death from accidental disconnection of the sampling system.

Alarm System and Mode Operation

Details the audible alarm's purpose and procedure for interrupted use with SET/RUN modes.

General Safety Precautions

Advises against ignoring alarms and stresses using genuine Engler hoses and fittings.