[Sentry Trailer – Operation, Startup, and Shutdown Procedures]
a. Be sure locking mechanism on cable is engaged.
b. Remove the coax cable, antenna, guy wires and put mast in towing position.
6. Remove all guy wires and carefully coil and return them to their color-coded pouches.
If you choose to remove the Duck Bill ground anchors, this can be readily accomplished by
digging straight down over the head with a post hole digger or shovel and then pulling back on
the eye towards the hole.
7. Raise the front leveling jacks until the weight is on the tongue jack.
a. Remove the front leveling jacks and stow them in the storage box.
8. Remove the rear outrigger leveling jacks and stow them in the storage box. Remove the hitch
pins from the outriggers and slide them into their stowed position and reinsert the hitch pins.
9. You are now ready to hook up the trailer to the tow vehicle.
a. Re-check all securing straps and safety wires.
b. Repeat procedure for “Getting ready to transport.”
11
To Next Page
Loading...