If you have previously installed a different camera:
i. Select ‘Video’
ii. Click on ‘Settings’
iii. Select ‘Add Video Device’
3. The camera should have now been discovered by the network.
a) If no devices have been detected:
i. Click on ’Refresh Devices’
ii. Search by entering the 12-digit MAC address of your video device
(found on the video device label) and click on ’Find’
4. Once the camera has been discovered name the Video Device
5. Click on ‘Install’ to add the camera.
6. Click on ‘Refresh Devices’ again. The camera should now be listed under ‘Video
Devices Installed’
4 | Enrolling Your Camera on ADT Interactive
b) Add a new device:
10
To Next Page
Loading...
