4B. Connecting in Access Point (AP) Mode
1. Connect AC power adapter and plug into an outlet
2. The camera’s LED will begin to flash white. If the LED is not white after two minutes,
hold down the ‘Reset’ button until the LED is flashing white (6 seconds)
Reset Button
Reset Button
3. Using your internet enabled device:
a) Search for available networks and connect to the wireless network ADC-V523IR
(XX:XX:XX). The (XX:XX:XX) is the last six digits of the camera’s MAC address
(located on the bottom of the camera or on the back of the packaging).
b) On the same device, open a web browser and enter the URL http://v523install
or 192.168.1.1 for indoor camera and URL http://v723install or 192.168.1.1 for
outdoor camera
3 | Connecting Your Camera to Wi-Fi
6
To Next Page
Loading...
