Regulatory Approvals
FCC Statement (US)
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designated to provide reasonable protections against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radiofrequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct
the interference by one of more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
FCC WARNING: This equipment may generate or use radiofrequency
energy. Changes or modications to the equipment may cause harmful
interference unless the modications are expressly approved in the
instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modication is made.
FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with a minimum distance of 20 cm between the radiator
and your body. End-users must follow the specic operating instructions
for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna
or transmitter.
Open-Source Software Notice
To obtain the source code under GPL, LGPL, MPL, and other
open-source licenses that are contained in this product, please visit
www.bluebyadt.com/opensource. In addition to the source code,
all referred license terms warranty disclaimers, and copyright notices
are available for download.
To Next Page
Loading...
Need help?
General
