ADT SASW3000EN User Manual

– 46 –
)LUH$ODUP6\VWHP&RQWLQXHG
THIS SECTION APPLIES ONLY TO RESIDENTIAL SYSTEMS
Manually
Initiating
a Fire Alarm
1. Should you become aware of a fire emergency before your smoke or
heat detectors sense the problem, go to your nearest touchpad and
manually initiate an alarm by pressing the panic key assigned for
FIRE emergency for 2 seconds. If a key pair has been assigned for
fire, press both keys at the same time. See Using the Panic Keys
section below for further details.
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify
your local Fire Department immediately.
4. If no flames or smoke are apparent, investigate the cause of the
alarm. The zone number(s) of the zone(s) in an alarm condition will
be displayed at the touchpad.
Using the Panic
Key(s) Assigned
for FIRE
Emergency
A key or key pair may have been assigned for manually initiating a
FIRE alarm. See the Panic Keys section for key assignments.
For convenience, indicate the key or key pair assigned for fire below.
Individual Keys
A BC
Press
the individual key assigned for fire
for 2
seconds.
OR
Key Pairs
1
OFF
and
∗ READY
∗ READY
and
#
3
STAY
and
#
DISPLAYS FOLLOWING MANUAL INITIATION OF A FIRE ALARM
*-6)

ALARM
FIRE
AC
CUSTOM DISPLAY TOUCHPAD
ENGLISH DISPLAY TOUCHPAD
Press
the key pair assigned
for fire
at the same time.

ADT SASW3000EN Specifications

General

Brand	ADT
Model	SASW3000EN
Category	Security System
Language	English