USING YOUR SYSTEM: EMERGENCY PANIC
Emergency Panic
If you have a police, fire, or medical emergency and your system is not armed or a sensor has not been triggered, you
can send a manual emergency panic by touching the icon in the bottom right corner and selecting the type of
emergency you are experiencing. (Note: If your system is a Keyholder response only monitoring package this option
will not be available.)
Cancel
Police: When touched it triggers the “Police”
siren pattern and sends a police emergency
signal to your provider’s monitoring station.
Available of police response systems only.
Fire: When touched it triggers the “Fire” siren
pattern and sends a fire emergency signal to
your provider’s monitoring station. Available
with ADT monitored smoke and heat detectors.
Emergency: When touched it triggers the
“Emergency” siren pattern and sends an
emergency signal to your provider’s monitoring
station.
Canceling an Emergency Panic
To cancel an emergency panic, touch the
“cancel” button and enter a valid user code.
To send a police or emergency panic
without sounding the siren, using the
“Silent Alarm” at the bottom of the screen
To Next Page
Loading...