USING YOUR SYSTEM: PARTITIONS
Partitions Access
When the panel is locked or the screen times
out, you will be required to re-enter your code
to gain access. The code you enter will
determine which partition you enter. Different
codes may gain access to all four partitions at
once or to one individual partition.
User Codes
Master codes give full access to Advanced
Settings. Because the Master code would be
entered here, you will not have to re-enter
your code to gain access to the settings menu.
User codes can be assigned to give access to
arming and disarming functions in a particular
partition. To assign single or multiple
partitions access to a User code, enter the
panel using the Master code and edit
permissions in the User Management settings
Enter User or Master Code to
gain access.
See page 13 for additional
instructions on how to access the
User Management menu.
Lock Screen
To lock your individual partition, swipe down
from the top to see the quick access menu.
Press the “Lock Screen” icon in the top left of
the menu. To switch from one partition to
another, you must first lock the screen then
re-enter a code for a different partition.
Once you enter a partition, no more codes are
required to access any settings or menus. It is
recommended to lock the screen when done
using the panel to prevent someone else
from gaining access to these menus and your
credentials.
Note:
You cannot partition Z-Wave or ADT’s cameras today. This functionality will come at a later date via software update. Global sounds
and sirens can be turned on from the Sound menu when partitions are enabled. When global sounds and sirens are turned on, all
sounds and sirens will sound across all partitions.
User Access
When creating a new user, you will be
given the option to grant that user
access to individual partition or all
partitions. Only the number of
partitions programmed will show up
here. Simply check the box next to
the desired option.
Important Note: If 6-digit codes are enabled in the panel but not changed in User Management,
the panel will add two Zeros to the end of the original code. Example: If original user code is 1234 and 6-
digit codes are enabled but the user code isn’t changed, the new user code will be 123400.
To Previous Page
Loading...
