ADT TSSC-FOB User Manual

TSSC-FOB - Installation and Setup Guide
WIRELESS KEY TRANSMITTER FOR USE WITH TSSC
GENERAL INFORMATION
The Wireless Key is a portable wireless transmitter for use
only with TSSC-BASE.
Buttons are typically used for arming and disarming, but can
be programmed for any appropriate zone response.
• To activate a programmed function press and hold the
appropriate key(s) until the LED begins to flash (about ½
second).
• The factory-installed replaceable lithium battery provides
power for up to 5 years.
The Wireless Key transmitter supports all eight (8) functions
and has a high security (encrypted) mode that sends rolling-
code encrypted messaging to the RF receiver.
ENROLLING THE TSSC-FOB
For complete details on how to enroll the Wireless Key
transmitter, access the TSSC Installer App
(https://portal.adtpulse.com/activation).
When enrolling, note the following:
• Each Wireless Key transmitter has two unique serial
numbers assigned during manufacture.
• Each button on the Wireless Key also has a distinct "loop"
number (refer to the Loop Number diagram above) that you
must program into the control during installation.
NOTE: Programming the Loop Number(s) can only be done
through the TSSC Installer App.
NOTE: Serial #2 is one (1) digit higher than serial #1, which is
printed on the rear of the transmitter.
USING HIGH SECURITY MODE IN TSSC-FOB
Activate High Security mode in the TSSC Installer App.
Activation syncs the Wireless Key with the security system.
ASSIGNING A WIRELESS KEY TO A USER
If the Wireless Key is assigned to arm and disarm the system,
the TSSC Installer App forces user assignment.
After enrollment, follow the instructions in the TSSC Installer
App.
Loop Numbers for the TSS
C
-
FOB
Buttons
tssc-001-V1
SERIAL #1
LOOP 4
SERIAL #1
LOOP 1
SERIAL #2
LOOP 1
SERIAL #2
LOOP 3
SERIAL #1
LOOP 3
SERIAL #2
LOOP 4
SERIAL #1
LOOP 2
SERIAL #2
LOOP 2
A
C
B
D
BUTTON 4
BUTTON 3
BUTTON 2
BUTTON 1
Using a Button: To activate a programmed function, press and hold the
appropriate buttons for at least one second or more. The LED will flash.
Note: The LED will continue flashing and transmissions will continue to be sent
ONLY while the button is being pressed.
For Serial #2 functions: If 2 appropriate buttons are pressed together for about
one second until the LED flashes and immediately released, the LED flashing
will continue. This confirms the 2 button function was accepted.

ADT TSSC-FOB Specifications

General

Brand	ADT
Model	TSSC-FOB
Category	Remote Control
Language	English