the network should make
negotiate queuing between
throughput, delay, reliability, and
cost.
Minimize Cost
Maximize
Reliability
Maximize
Throughput
Minimize Delay
Time to live is a numeric value
from 1 to 255 that specifies the
number of iterations or
transmissions the packet can
undergo before it is discarded.
The default value is 7.
sets the physical connector (on
the rear of the unit) to use for
multicast transmit purposes on
the indicated encode channel.
Select both services or single
service transport stream
Configures the TMR of the IP
output.
Note:only usable in SPTS mode
Configure Multi Mux Rate to auto
or manual mode
Note: Four IP destinations are available on the product. The ‘#’ denoted in the IP Tx
Commands above are relevant to the four destinations indexed 0 - 3.
To Next Page
Loading...
