ADURO H1 - Installation of the Stove; 2.1 Position and Distance Requirements

56
1.5 Transportation
When taking your Aduro H1 & H3 LUX home, please ensure that it travels in an upright position. The
packaging must be disposed according to national rules regarding disposal of waste.
2. Installation of the stove
You are welcome to install your hybrid stove yourself – but we strongly recommend that you consult your
chimney sweep before you begin the installation. It is important to ensure that all local rules and regulations,
including ones relating to national and European standards, are complied with when installing this device.
Your dealer can also provide you with installation advice. Remember, it is your responsibility that rules in
force are complied with.
We do not recommend connection to a contentric chimney.
APPLIES TO UK INSTALLATION ONLY: To comply with UK building regulations an approved CO monitor
should be installed in the same room as the appliance.
2.1 Position of the stove and distance requirements
If the stove is placed near combustible material, specific distance requirements apply. See table and
illustrations below:
Distance to flammable
material (cm)
Aduro H1
Aduro H2
Aduro H3 Lux
Aduro H4 Lux
Aduro H5
To the side (A)
70
10 / 40
70
10 / 40
27.5 / 37.5
Behind the stove (B)
7.5
7.5
7.5
7.5
7 cm behind
the stove (5
cm from air
intake)
To furniture (C)
100
100
100
100
100
For corner installation (D)
-
10
-
10
-
You may not begin to use the hybrid stove until it has been inspected and
approved by your local chimney sweep.