Edited 13.10.2023.
2
• Check that the door is airtight and check that the door gaskets are placed correctly. Tighten the
glass fittings.
• Check that the smoke extractor fan and convection fan is working properly.
• Check the temperature sensor is mounted correctly on the backside of the smoke extractor fan, and
that it is covered with felt and a metal cover.
• Empty the pellet container and vacuum the bottom of the external auger through the opening in the
pellet container, clean any pellet dust that might have accumulated here.
• Carefully remove the control board and clean it for dust using compressed air. Check the cables for
damage and that all are connected correctly.
To Next Page
