ADURO Hybrid User Manual

How to replace the Hybrid stove’s control board
1. Before you start replacing the control board, it is important to check if the cables are inserted correctly (not
loose). Check if input L1-L4 are glowing when you choose manual mode in the H1 app (turning on
gearmotor, igniter, fan). If you confirm that the control board is not reacting to any commands, please follow
these steps:
a) Disconnect the stove from all electricity by unplugging the power plug.
b) Locate the control board. The entrance for the control board can be found in the stove’s bottom left corner.
See pictures below. Unscrew the two screws and pull the control board slowly out.
2. Once you have taken the control board out:
a) Take a picture of the whole control board for you to remember how it looks and how the different inputs
are connected. Start unplugging the display cable on the control board. See step 4 for illustrations regarding
how the connections should look like.
b) Unplug the rest “Green bricks”, which are input for the different electronical parts of the stove (sensors,
gearmotor, igniter etc. This is done by pulling the brick up without removing the cables itself. See pictures
below.

ADURO Hybrid Specifications

General

Flue Diameter	150 mm
Material	Steel
Fuel Type	Wood / Pellets
Flue Outlet	Top/Rear
Heating Capacity	2-8kW
Heat Output	2-8 kW

Summary

Prepare for Control Board Replacement

Disconnect Stove from Power

Disconnect the stove from all electricity by unplugging the power plug before proceeding.

Locate and Remove Control Board

Locate the control board in the stove's bottom left corner and unscrew the two screws to pull it out.

Control Board Post-Removal Steps

Document Control Board Connections

Take a picture of the control board to remember input connections before unplugging.

Unplug Green Input Bricks

Unplug the 'Green bricks' (inputs for sensors, gearmotor, igniter) by pulling the brick up.

Install New Control Board and Reconnect

Remove Old Control Board

Unscrew the 4 screws in each corner to remove the old control board.

Install New Control Board

Replace the old board with the new one and screw it in place with 4 screws.

Reconnect Green Input Bricks

Plug the 'Green input bricks' back into their correct positions.

Reconnect Display Cable

Insert the display cable into its connector on the new control board.

Power On and Test

Insert the power plug, wait for restart, and check if the display keyboard lights up.

Control Board Component Placement Guide

Screen Cable and Service Connections

Details on connecting the screen cable and service interface.

Keyboard/Controller Connection

Information on connecting the keyboard or controller unit.

Power Input Connections

Wiring diagram for power supply (PE, N, L).

Auger and Blower Connections

Wiring for external auger, internal auger, and blower.

Ignition and Sensor Connections

Wiring for ignition, temperature sensors, and room temperature.

Other Input/Output Connections

Guide for CO meter, damper contact, door contact, and smoke temperature.