The MIGRO system limits the voltage in the grow room to 96Vdc and has
built in protection for overcurrent, shorts or overheating. However, to
minimise any remaining risk please switch the power off while installing and
adjusting the MIGRO system. If the mains plug needs to be changed to suit
your power socket only a qualified person should carry out this work, in
accordance with your local codes.
The MIGRO system will operate on a supply voltage ranging from 100V to
277V AC and from 50 to 60Hz frequency. Any other supply voltage will
damage the lighting system.
The grow light and the cabling from the LED driver to the grow light is IP66
rated and can be used in a wet area. The mains power plug is not IP rated for
a wet area and should be located in a dry area outside of the grow room. If
the cable insulation or glands are damaged switch off the system
immediately and return to us for repair.
The MIGRO grow light has a highly efficient and passive cooling heatsink. In
order to function correctly air must be able to flow freely across the fins of the
heatsink. Do not cover the grow light and restrict the airflow across the
heatsink under any circumstances. This will result in heat build up which may
damage the grow light and/or cause a fire.
Do not put the grow light down on any surface when the light is on. The light
intensity and radiated heat may damage the surface.
The light intensity from each MIGRO grow light is very high. If you look
directly at the light source from less than 20cm or 9” away the intensity is
equivalent to the sun. To protect your eyes do not look directly at the light
source when less than 60cm or 2 feet away.
To Next Page
Loading...
Need help?
General