If the driver case temperature gets to 90 Deg C or 195 F the output current
will be reduced. If the temperature does not reduce, then it powers off until
temperatures have reduced.
Maintenance
The MIGRO grow light system requires almost no maintenance. In ordinary
use the only maintenance required is to keep the heatsink and the led
surface clean. This will ensure the cooling performance and light output are
maintained, respectively.
To clean all of the components switch off the power and use warm water and
soap with a damp cloth. Do not under any circumstances use a solvent, acid
based or an abrasive cleaner on any of the components. Doing so may
damage the finish of the product and the electrical and led coating
Typical Package contents:
Email: info@advancedgrowlights.com
Website: https://advancedgrowlights.com
YouTube: MIGRO channel – optimize your grow light setup
To Previous Page
Loading...
Need help?
General